Filter
Top Products
Installing WinFax PRO 8.0
Issue 1 CRCS R6.0 April 1999 33
Installing WinFax PRO 8.0
If you are upgrading from an earlier release of CRCS that uses WinFax PRO 7.5,
CRCS 6.0 will also support that software version and the faxmodems installed
according to the instructions found in the
CRCS Installation
manual that came
with your previous release.
NOTE:
WinFax 7.5 is only compatible with Microsoft Windows 95 platforms; use
WinFax 8.0 if installing on a Microsoft Windows NT 4.0 workstation.
1. Install your faxmodem according to manufacturer instructions and connect
to COM2.
NOTE:
If CRCS is managing two MCUs, install the faxmodem on COM3 or COM4.
This requires either an internal modem or installation of a serial card to use
an external modem.
2. Close all programs and insert the WinFax PRO 8.0 CD-ROM into your
CRCS PC.
3. If AutoPlay is enabled, the program loads automatically. Otherwise, run
setup.
4. Select the INSTALL WINFAX PRO option.
5. Select INSTALL NOW.
6. Read the licensing agreement and click Next.
7. Read the Introduction screen and click Next.
8. From the
WinFax PRO Setup - User Information
window, enter your name
and company and click Next.
9. From the
WinFax PRO Setup - Installation Type
window, select Typical
Installation and click Next.