Filter
Top Products
14 Issue 1 CRCS R6.0 April 1999
Connecting the PC to the MCU
11. When the login for the MCU displays, enter the login and password
assigned by the technical center during installation to verify that you have a
working CRCS to MCU link.
12. Type logoff and exit hyperterminal. Repeat this procedure to test COM2 if
you are controlling a second MCU.
NOTE:
If the MCU login does not display, verify that the MCU recognizes that
CRCS is active (from the MT check the
Scheduler Adjunct
field on the cus-
tomer-options form. It must be set to y).
13. Continue to "CRCS/OpCenter Software Installation" on page 15 to load the
CRCS/OpCenter program.