Filter
Top Products
SECTION 1 SECTION 2 SECTION 3
SECTION 4
KPS 25s
DIRECT AGCESS CONTROLLER
SECTION 7 SECTION 6 SECTION 5
2 SPDIF co-axial digital outputs (via The XLR pin
RCA connectors)
below:
1 AES/EBU digital output (via an XLR
Pin 1
connector)
Pin 2
KrelP recommends the use of balanced
Pin 3
interconnects. Balanced interconnects not
only have the ability to minimize sonic loss
but also have immunity to induced noise,
especially for installations using long cable
configuration is described
Ground
Non-inverting (0
°)
Inverting (180")
The left and right channel RCA and bal-
anced outputs are labeled on the back
panel. Please maintain the correct left/right
orientation.
more gain than single-ended connections.
When level matching is critical, keep this
specification in mind.
Page 10 of 20 Engllsh
lengths. Balanced connections have 6dB
NOTE: Both ba/anced and single-ended
outputs can be used to simultaneously feed
different systems.
When the KPS 25s is connected directly to
a stereo power amplifier or a pair of monau-
ral power amplifiers, use the variable output
terminals to insure proper level control.
KRELL
®
KPS 25a