Filter
Top Products
3-l. FRONT PANEL
1
F. LOCK Indicator
This indicator will light when the LOCK switch is turned ON
(VFO frequency is locked).
2 BUSY Indicator
This indicator lights when the squelch is open in FM or.FM-
CH receive mode, allowing the Operator to check whether
the other Station is transmitting.
3 ON AIR Indicator
This indicator will light during transmission.
4 OFFSET Indicator
This indicator lights when the TX OFFSET switch is set to
the D
-
A or D
-
B Position for repeater Operation.
5 Meter
This meter has four functions,
each
being selected by using
the meter select switch.
RFIS:
The meter serves as “S” meter indicating the
strength of received
Signal
on a scale graduated
from 1 to 10 (FM), or 1 to 9,
9+20
dB and
9+40
dB (SSB
CW).
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
F. LOCK Indicator
BUSY Indicator
ON AIR Indicator
OFFSET Indicator
Meter
TX-OFFSET Switch
REV (Reverse) Switch
TONE Switch
LOW POWER Switch
NB
(noise
blanker) Switch
Meter Switch
VOX Switch
Standby Switch
POWER Switch
MIC Connector
PHONES
Jack
MODE Switch
PRIO.
M Switch
TIGHT Level
F. STEP Indicator
Tuning Knob
FUNCTION Switch
MEMORY Selector
SSB MIC
RIT Indicator
RIT Control
IF SHIFT Knob
SQUELCH Control
SCAN-W
AF GAIN Control
RF GAIN Control
F. STEP Switch
RIT Switch
SCAN Switch
HOLD
M. S Switch
BAND Switch
M (Memory) Switch
F. LOCK Switch
M.
R
(Memory
Recall)
Switch
During transmission, the meter indicates RF
output.
ALC/CEN: In FM receive mode (MODE switch in FM, FM-
CH position), the meter functions as a Center
meter. Turn the VFO knob to your desired
receive
Signal
until the meter pointer is
centered.
In other operating mode (SSB,
CW),
the meter
indicates the transmitter ALC voltage. In SSB
Operation, adjust the MIC gain control so that
the meter pointer deflects within the ALC zone
on the scale. In CW Operation,
adjust
the CAR.
L knob.
6 TX-OFFSET Switch
This switch is used to shift the TX frequency from the RX
frequency for repeater Operation. After the repeater opera-
tion, it should be set to the SIMP Position; the TX frequen-
cy will coincide with the RX frequency. In case of Off-band,
the frequency is not shifted and the transceiver is set in
simplex mode.
5