Filter
Top Products
60
Note:
◆ When the CTCSS or DCS function is activated, the transceiver
stops at a busy frequency and decodes the CTCSS tone or DCS
code. If the tone or code matches, the transceiver unmutes.
Otherwise, it resumes scanning.
◆ Press and hold [MONI/SQL] to pause scan in order to monitor
the scanning frequency. Release [MONI/SQL] to resume
scanning.
◆ While the transceiver is in VOX Mode or transmitting, it causes
scan to stop (excluding Priority Scan).
◆ Pressing [MENU] causes scan to stop.
◆ Starting scan switches OFF the Automatic Simplex Check (ASC)
{page 38}.
◆ If you press any key other than the following keys during scan,
the transceiver exits scan (excluding Priority Scan). Priority Scan
stops while “Pr” is blinking: [F], [F] (1 s), [LAMP], [MONI/SQL],
Tuning control, and [F] then [MONI/SQL].
NORMAL SCAN
When you are operating the transceiver in VFO Mode,
2 types of scanning are available: Band Scan and
Program Scan.
Band Scan
The transceiver scans the entire band of the frequency
you selected. For example, if you are operating and
receiving at 144.525 MHz, it scans all the frequencies
available for the 2 m band. (Refer to receiver VFO
frequency range in the specifications {page 122}.) When
the current VFO receive frequency is outside the Program
Scan frequency range {page 59}, the transceiver scans
the entire frequency range available for the current VFO.
1 Press [VFO].
2 Turn the Tuning control to select the frequency
outside of the Program Scan frequency range.