Kenwood TH-K4AT Stereo System User Manual


 
111
MICROPROCESSOR RESET
If your transceiver seems to be malfunctioning, resetting
the microprocessor may solve the problem. The
following 2 reset Modes are available. When performing
the reset, you may lose memory data and stored
information. Back up or write down important data
before performing the reset.
Initial Settings
The factory defaults for the operating frequencies are as
follows:
TH-K2AT/ E/ ET: 144.000 MHz
TH-K4AT/ E: 430.000 MHz
The Memory channels have no data stored. The
Weather Radio frequency (AL channel) is restored as
162.550 MHz (TH-K2AT K/ K2 only). Refer to pages 53,
55 and 87 for the Call Channel, Weather Radio
frequency and frequency step size default values.
Full Reset
This resets all transceiver parameters to the factory
default values.
VFO Reset
This resets the transceiver parameters excluding the
stored DTMF Number in Memory {page 77} and
memory channel contents.
Note: While transceiver is operating in the Channel Display Mode
{page 57}, you cannot reset the transceiver.