Filter
Top Products
79
Troubleshooting
Receiver/Tuner
• The surround setting—see “What are Listen Modes?” on page 18
of this manual
• The speaker settings—you will need to reset your speaker settings
( see Chapter Two of the Connections and Setup Guide)
Reset the cleared settings before operating the receiver again.
The sound is distorted, and the CLIP indicator on the receiver’s
front panel flashes red continually, or stays red for more than 1
second at a time
Lower the analog input level for the source component you’re listening
to. (Setting the proper input level eliminates distortion that occurs if a
source component’s output level is too high. When this happens, the
front panel CLIP indicator will flash red continually or remain red for
periods of 1 second or longer. Occasional brief flashing of the CLIP indi-
cator is okay). Adjust the analog input level for that component: See “Ad-
justing the Input level” on page 15 of this manual.
I can’t receive a radio station
Check that:
• The appropriate antenna is connected. See Chapter One of the Con-
nections and Setup Guide.
• The broadcast band is correct. See “Radio Tuning” on page 44 of this
manual.
• The tuner is set to the correct frequency. See “Radio Tuning” on page 44
of this manual.
I can’t access any RDS (Radio Data System) functions (U.K. only)
• Confirm that the radio station is broadcasting RDS.
• Make sure you use the Auto Memory function to store RDS stations in
memory. See “Storing RDS Stations Automatically” on page 46 of this
manual
I’m getting a lot of static/interference
• Check whether the receiver or antenna is too close to a TV or other
electrical appliance.
• Adjust the antenna for best reception.
• If you live in an area with weak FM signals, consider a rooftop FM
antenna (available at any home electronics store).