Filter
Top Products
78
Moving Around
Troubleshooting
Receiver/Tuner
Receiver/Tuner
My receiver won’t turn on and the STANDBY indicator is flashing
Your receiver is in the “protection” mode.
Check that:
• The speaker system’s impedance is not too low. See Chapter One of
the Connections and Setup Guide.
• The speaker wires are not short-circuited. Test the wires as follows to
find the shorted wire and replace it:
1 Turn off the receiver, disconnect the positive and negative speaker
wires of the RIGHT FRONT speaker from the receiver, and turn
the receiver back on.
2 If the STANDBY indicator stops flashing, replace this wire.
3 If the STANDBY indicator does not stop flashing, turn off the re-
ceiver, reconnect the speaker wires, and repeat the first step for the
next speaker.
4 Continue until you have isolated and replaced the shorted wire.
5 See Chapter One of the Connections and Setup Guide.
If none of the above solutions work, reset the microprocessor:
1. Turn the receiver off.
2. Press ON/STANDBY button while pressing and holding the Power
button.
3. Plug it back in while pressing and holding the Power switch (you may
need someone else to help you do this)
• The component set as input (Tuner is selected by default)—see
“How Do I Operate Devices?” on page 36 of this manual.
• The volume setting (-48dB is selected by default)—see “Adjusting
the Volume” on page 10 of this manual
• The tuner’s receiving band (FM is selected by default)— see “Ra-
dio Tuning” on page 44 of this manual
• The tuner’s frequency (87.5MHz is selected by default)— see “Ra-
dio Tuning” on page 44 of this manual
• The tuner’s preset memory—you will need to reset your stored
radio stations (see “Presetting radio stations” on page 46 of this
manual)