Filter
Top Products
77
Troubleshooting
• Check that the correct video input on the TV is selected.
• Check that the video software you record does not have copy guard
protection.
• All Zone B inputs must be composite. S-Video is not supported in
Zone B.
Remote Control unit
My Remote Control unit is slow to respond—sometimes I have to
press buttons or select commands several times
• If Remote Control unit is in sleep mode (the screen is blank), the first
button press “wakes it up”. The second press performs the action.
• Your Remote Control unit supports 2-way communication with the
receiver. If the 2-way communication indicator on the front of the
receiver is lit, Remote Control unit is receiving information. It cannot
transmit your new command until it is finished receiving informa-
tion from the receiver.
My Remote Control unit is not responding
• Make sure you are within the operating range for Remote Control
unit. See “Remote controllable range” on page 7 of this manual.
• Replace the batteries. See Chapter Two of the Connections and Setup
Guide.
• If you’re using an IR receiver, make sure it is connected properly and
turned on. See Chapter four of the Connections and Setup Guide.
• Check the contrast of the LCD display is adjusted properly. See “How
Do I Adjust the LCD Display” on page 52.
• If you want to use Remote Control unit by setting the control mode
to Zone B, make sure that the Multi-Zone function is On. If this func-
tion is Off, you cannot control Zone B from Remote Control unit.
I want to clear all the items in Remote Control unit and make it to
the factory-set default condition.
1. Remove the batteries.
2. While holding the (function up) button and button
simultaneously, load the batteries.
After the above, all settings are reset to the factory settings.
Video/Remote Control unit