Filter
Top Products
45
Using Receiver
How Do I Operate Devices?
To tune into a radio station:
1. Select the Tuner input (see page 35).
2. Select the FM or AM band.
MULTI
CONTROL
fi%
P.CALL MEMORY AUTO BAND
fi%
+
-
+
-
/8
/7
1
1
• Press the BAND button on the receiver
• Or press the ENTER (BAND) button on Remote Control unit.
3. Press Remote Control unit’s TUNING (2/1, 3/¡) button or the
receiver’s MULTI CONTROL (%/fi) button to start Auto tuning until
the desired station is tuned in.
If the radio wave from the station is weak and hard to tune in, press
the AUTO/MONO buttons on Remote Control unit or AUTO button
on the receiver to select Manual tuning. In this mode, each press of
the TUNING button varies the tuning frequency by one step.
To tune into a preset station:
1. Select the Tuner input (see page 35).
2. Press Remote Control unit’s 4 or ¢ button or the receiver’s P.CALL
(%/fi) button. Each press of the button switches the preset station
(see “Presetting radio stations” on page 46).
+
-
+
-
/8
/7
1
1
When select a preset station using the numeric buttons: Press the nu-
meric buttons as shown below.
To select 25: , ,