Filter
Top Products
Make connections as shown below,
Do not connect the power cord to a wall outlet until all connections are completed.
Antenna terminal connections
O Push lever, O Insert cord. O Return lever.
VR-2090/VR-2080/KRF-V8881D/KRF-V7 7 71D (Era/K}
AM loop antenna FM indoor antenna
The supplied loop antenna is for _se ndoors. Place it as far as possible
from the receiver, TV set, speaker cords and power cord, aRd adjust the
direction for best reception,
The supplied indoor antenna is for temporary use only For stabe e_nal
reception we recommend using an outdoor antenl_a Disconnect tt_e
i[',dool al_telii/a when If'eLICoRRect one outdoors.
FM outdoor antenna
Lead the 75£_ coaxial cab}e connected to the FM outdoor antenna into
the room and connect it to the FM 7511 term nal,
FM DE-EMPHASIS/CHANNEL SPACE switch ...............
(Except for U.S.A., Canada, China and Australia )
The FM DE-EMPHASIS/CHANNEL SPACE switch on the rear panel s
set to the correct setting that prevails in the area to which the uni[ s
shipped, However, if the FM DE-EMPHASIS!CHANNEL SPACE setting
s not matched to the area where the unit is to be used; for instance,
when you move from ares 1 to area 2 Orvice versa, desired reception of
AM / FM broadcasts is not expected, tn this case, change the FM DE-
EMPHASIS / CHANNEL SPACE setting in accordance with the area
corresponding to the table, The FM DE-EMPHASIS is switched over at
the same time.
AM 10kHz
FM 10el<Hz
50ps
AM 9kHz
FM 50kHz
• When changing the setting of the FM DE-EMPHAS S / CHANNEL
SPACE sw tch, first d sconnect the power cord, then reset the channel
space switch, connect the power cord again, and turn the power on.
1
2
CHANNEL
Area SPACE freq,
USA. Canada, FM; 100kHz
and South Ameri-
can countries AM: 10kHz
FM
DE-EMPHASIS
75 ps
Other countries FM: 50kHz 60ps
AM: 9 kHz