Kenwood VR-4900 Stereo System User Manual


 
Rooms
88
How Do I Operate Devices?
How Do I Operate Devices?
General instructions for operating any device are given under “How Do I
Operate Devices?” on page␣ 29. Some operations, however, are a little dif-
ferent depending on the room you are in. The following section discusses
how devices may operate differently in different rooms.
Operating Devices in Room A
To select the speakers for Room A, press the button for Speakers–A on the
front panel of the receiver.
To set up PowerTouch to control Room A devices, follow the instructions
under “How Do I Switch Control Modes?” on page 86.
To control a second CD player from Room A, use
, unless you are
using a Kenwood 200-Disc CD Changer (see below).
Kenwood CD-3280M, CD-2280M, DPF-J9010, DPF-J9020 or DPF-J9030
200-Disc CD Changers are specifically designed to work with the VR-
4900/KRF-V9993D in a dual-room environment. Since they contain two
CD players, one can play in Room A while the other is playing simulta-
neously in Room B. Use CD1 to control the changer for Room A and CD2
to control the changer for Room B.
Operating Devices in Room B
If you are using the receiver’s Speaker B outputs to power the speakers in
Room B, press the button for Speakers-B on the front panel of the re-
ceiver to activate the speakers in Room B. The Listen Mode in Room A
will automatically switch to stereo when you turn Speakers B on.
To set up PowerTouch to control Room B devices, follow the instructions
under “How Do I Switch Control Modes?” on page 86.