Filter
Top Products
Receiving broadcast station
25
EN
One-by-one presetting (Manual preset)
1 Select the AUTO or MANUAL mode.
2 Tune a station.
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good:
AUTO mode
When it is poor due to weak radio waves:
MANUAL mode
In AUTO mode :
The next preset station can be received automatically
every time the TUNING (1 or ¡) key is pressed.
In MANUAL mode :
Press the TUNING (1 or ¡) key repeatedly until the
desired station is received. The desired station can
also be received by holding the TUNING (1 or ¡)
key depressed until its frequency is displayed.
To increase
frequency
To decrease
frequency
Each press alternates the mode.
1 "AUTO" :
Stereo reception ("AUTO" lit)
2 "MANUAL" :
Monaural reception ("AUTO" not lit)
1 Perform the procedure in "Tuning to a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2 Press the ENTER key during reception.
3 Select one of the preset numbers from
1 to 30.
4 Press the ENTER key again.
÷ In MANUAL mode, FM stations are received in mon-
aural.
÷ Normally, use the AUTO (Auto tuning, stereo recep-
tion) mode.
÷ A maximum of 30 stations of the band presently being
received will be preset.
(Repeat steps 1, 2, 3 and 4 to preset other sta-
tions)
÷ If several stations are preset under the same number,
the previous memory is replaced with the latest
memory contents.
(Proceed to step 3 while "MEMORY" is lit.)
"MEMORY" lights (for approx. 20 sec.)
÷ The same operation is also available with the 7
[Tuning Mode] key on the main unit.
Tuning to a non-preset radio station (Auto tuning, Manual tuning)
Remote control unit only
AUTO/MONO
STOP/
RETURN
TUNING
Remote control unit only
ENTER
P
R
E
V
.
N
E
X
T
P.CALLP.CALL
0
8
5
2
9
6
3
7
4
1
10
ENTER
5281/21-25/EN 6/13/02, 9:32 AM25