Filter
Top Products
33
Receiving broadcast station
Basic section
One-by-one presetting (Manual preset)
1 Select the AUTO or MANUAL mode.
2 Tune a station.
Tuning a non-preset radio station (Auto tuning, Manual tuning)
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good: AUTO
mode
When it is poor due to weak radio waves:
MANUAL mode
Auto tuning mode :
Each press receives a new station.
Manual tuning mode :
Press repeatedly until the desired station is received.
To increase
frequency
To decrease
frequency
Each press alternates the mode.
1 "AUTO" : "AUTO" lit
2 "MANUAL" : "AUTO" not lit
1 Perform the procedure in "Tuning a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2 Press the ENTER key during reception.
3 Select the desired preset number between
1 and 40 using the numeric keys on the re-
mote control unit.
4 Press the ENTER key again.
÷ In MANUAL mode, FM stations are received in monau-
ral.
÷ Normally, use the AUTO (Auto tuning, stereo reception)
mode.
÷ Repeat steps 1~4 to preset other stations.
÷ If several stations are preset under the same number,
the previous memory is replaced with the latest
memory contents.
STOP
AUTO/MONO
7
TUNING DOWN
TUNING UP
1
¡
ENTER
123
456
78
9
+ 100 0
+ 10
ENTER
MEMORY
P--
MEMORY P12
Press the numeric keys as shown below....
12........................... +10, 2
20........................... +10, +10, 0
Remote control unit only