Filter
Top Products
Application section
HM-381MD (En)
47
Program recording
(CD
=
MD / CD
=
TAPE)
Desired CD tracks can be programmed in the desired sequence and recorded onto an MD or tape.
Recording preparation is required.
º¤
(Be sure to put the MD recorder and cassette deck in stop mode.)
Convenient Recording Methods
1
MD
O.T.E.
TAPE
MD
O.T.E.
TAPE
Start recording.
2
7
To interrupt a recording
(Recording and playback will be
stopped.)
At the end of the recording
MD recorder : Stop.
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
“WRITING” displayed during the minidisc ejection
operation indicates that the data associated with
recording or editing is being written on the disc. Do
not apply vibration or shock to the unit while this
message is displayed.
Always remove the disc after recording.
Note
Note
CD
=
MD CD
=
TAPE
Perform steps 1 and 2 of the procedure in
”Listening in the desired sequence (Program
playback)”.
›
Perform steps 1 and 2 of the procedure in
”Listening in the desired sequence (Program
playback)”.
›
÷ When the PGM key is pressed to cancel the edited contents, the entire editing contents will be erased.
÷ Tracks programmed beyond the available MD or tape recording time will be interrupted in the middle.
÷ Recording of the programmed tracks in the programmed order starts.
÷ When starting recording from the remote control unit, make sure not to mistake the MD O.T.E. key and TAPE O.T.E. key.
÷ To perform operation on the main unit, see step 3 in the procedure in ”Twin recording onto MD and tape (TWIN REC)”.
y
Program the desired sequence of CD tracks.