Filter
Top Products
44
Troubleshooting
PROBLEM
The STANDBY lamp lights up after
turning on the power, but soon the unit
turns off (into standby mode).
Remote control does not operate as you
intend.
Remote control does not work.
SOLUTION
Press STANDBY/ON
on the front panel
to turn off the unit. After unplugging the
power cord, consult your dealer.
Press SOUND or a source selecting button
first, then press the buttons you want to use.
(See pages 39 and 40.)
Remove the obstruction.
Replace batteries.
Set RDS/DVD MENU selector to the proper
position.
Note:
When you use the digital coaxial connection, the sounds may be intermitted by the outside noise such as a lightning discharge but they will
restore automatically. This is not a malfunction.
POSSIBLE CAUSE
The unit is overloaded because of a
high voltage.
The remote control is not ready for
your intended operation.
There is an obstruction hiding the
remote sensor on the unit.
Batteries are weak.
RDS/DVD MENU selector is set to the
incorrect position.
EN38-46.RX-E111&112RSL[B]_f 02.1.22, 8:55 AM44