Filter
Top Products
25
FM/AM
To restore the stereo effect
Repeat step
1
, then select “AUTO MUTING” in step
2
.
When using the remote control
1
Press FM.
10 keys now work for tuner operations.
2
Press FM MODE.
• Each time you press the button, the FM reception mode
alternates between “AUTO MUTING” and “MONO.”
STTUNED
AUTO MUTING
MH
Z
VOL
R
T
CONTROL
Tuner Operations
R ΙΙ
STTUNED
AUTO MUTING
VOL
O
SR
T
ATT
CONTROL
R ΙΙ
STTUNED
AUTO MUTING
VOL
O SR
T ATT
ANALOG
PR ΙΙ
SUBWFRLFE
TUNED
VOL
AUTO SR
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
Ex.: When selecting the FM band.
Selecting the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, you can
change the FM reception mode while receiving an FM broadcast.
• You can store the FM reception mode for each preset station (see
page 24).
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1
again.
1
While listening to an FM station, press
CONTROL ∞ (or 5) repeatedly until
“< FM MODE >”
appears on the display.
2
Press CONTROL 3 (or 2) to select “MONO.”
• Each time you press the button, the FM reception mode
alternates between “AUTO MUTING”* and “MONO.”
* “AUTO MUTING” is the initial setting. If you have already
changed the setting, “MONO” will be shown.
AUTO MUTING: Normally select this.
When a program is broadcasted in stereo,
you will hear stereo sound; when in
monaural, you will hear monaural sounds.
This mode is also useful to suppress static
noise between stations. The AUTO
MUTING indicator lights up on the display.
MONO : Select this to improve the reception (but
stereo effect will be lost).
In this mode, you will hear noise while
tuning into the stations. The AUTO
MUTING indicator goes off from the
display. (The ST indicator also goes off.)
CONTROL
To tune in a preset station
1
Press FM/AM to select the band.
The last received station of the selected band is tuned in, and the
CONTROL buttons now work for tuner operations.
2
Press CONTROL ∞ (or 5) repeatedly until
“< PRESET >” appears on the display.
3
While “< PRESET >” still remains on the display,
press CONTROL 3 (or 2) to select a preset
channel number you want.
• Pressing (or holding) CONTROL 3 increases the preset
channel numbers.
• Pressing (or holding) CONTROL 2 decreases the preset
channel numbers.
When using the remote control
1
Press FM or AM.
The last received station of the selected band is tuned in, and the
10 keys now work for tuner operations.
2
Press the 10 keys to select a preset channel number.
• For channel number 5, press 5.
• For channel number 15, press +10 then 5.
• For channel number 30, press +10, +10, then 10.
CONTROL
STTUNED
AUTO MUTING
MH
Z
VOL
EN23-29.RX-E111&112RSL[B]_f 02.1.17, 9:20 AM25