Filter
Top Products
14
Basic Settings
• To play back software encoded with Dolby Digital, select
“DGTL D.D.”
• To play back software encoded with DTS Digital Surround,
select “DGTL DTS.”
Note:
When you turn off the power or select another source, “DGTL DTS”
and “DGTL D.D.” are canceled and the digital input mode is
automatically reset to “DGTL AUTO.”
The following are the analogue/digital signal indicators on the
display to indicate what type of the signal comes into the unit.
ANALOG : Lights when the analogue input is selected.
LPCM : Lights when Linear PCM signals come in.
DOLBY D : • Lights when Dolby Digital signals come in.
• Flashes when “DGTL D.D.” is selected for
software not encoded with Dolby Digital.
DTS : • Lights when DTS Digital Surround signals
come in.
• Flashes when “DGTL DTS” is selected for
software not encoded with DTS Digital
Surround.
Note:
When “DGTL AUTO” cannot recognize the incoming signals, no digital
signal indicators light up on the display.
SETTING INPUT
ANALOG/DIGITAL
Display
CONTROL
5/∞/3/2
SUBWFRLFE
V
O
LCR
LS RS
DOLBY D
INPUT
ANALOG/DIGITAL
INPUT ATT
Remote
NOT
CONTROL
STB VCR TV TAPE
FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST
SETTING
STANDBY
INPUT
ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND
ON/OFF
SURROUND
MODE
ANALOG
PL ΙΙ
SUBWFRLFE
SLEEP MODE TA
STTUNEDINFO
HEWS
AUTO MUTING
MH
Z
KH
Z
VOL
AUTO
AUTO SR
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
PHONES
RDS
HP
DGTL AUTO :Select this for the digital input mode. The unit
automatically detects the incoming signal
format, then the digital signal indicator for the
detected signals lights up.
ANALOGUE :Select this for the analogue input mode.
If the following symptoms occur while playing Dolby Digital or
DTS Digital Surround software with “DGTL AUTO” selected,
follow the procedure below:
• Sound does not come out at the beginning of playback.
• Noise comes out while searching for or skipping chapters or
tracks.
1
Press INPUT ANALOG/DIGITAL (INPUT
ATT)—or ANALOG/DIGITAL INPUT on the
remote control—to select the digital input mode
(“DGTL AUTO”).
2
Press CONTROL 3 (or 2) to select “DGTL
D.D.” or “DGTL DTS” while “DGTL AUTO”
still remains on the display.
• Each time you press the button, the digital
input mode changes as follows:
EN10-19.RX-E111&112RSL[B]_f 02.1.17, 9:19 AM14