Filter
Top Products
13
Setting the Digital Input
(DIGITAL IN) Terminals
When you use the digital input terminals, register what components
are connected to which terminals (DIGITAL IN 1/2) so that the
correct source name will appear when you select the digital source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1
again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
2
Press CONTROL ∞ (or 5) repeatedly until
“DGT (Digital)” (with the current setting)
*
appears on the display.
* “1DVD2STB” is the initial setting. If you have already
changed setting, another combination will be shown.
3
Press CONTROL 3 (or 2) to select the
appropriate digital terminal setting.
• Each time you press the button, the display changes to show
the following:
Basic Operations / Basic Settings
Note:
When shipped from the factory, the DIGITAL IN terminals have been
set for use with the following components:
– DIGITAL 1 (coaxial): For DVD player
– DIGITAL 2 (optical): For STB (Set Top Box)
Selecting the Analogue or Digital Input Mode
When you have connected digital source components using both the
analogue connection and the digital connection methods (see page 7),
you need to select the input mode correctly.
1
Press one of the source selecting buttons (DVD,
STB, or TV)
* for which you want to change the
input mode.
Note:
*
Among the sources listed above, you can select the digital input
only for the sources which you have selected the digital input
terminals for. (See “Setting the Digital Input (DIGITAL IN)
Terminals”.)
2
Press INPUT ANALOG/DIGITAL (INPUT
ATT)—or ANALOG/DIGITAL INPUT on the
remote control—to select the analogue or digital
input mode.
• Each time you press the button, the input mode alternates
between the analogue input (“ANALOGUE”*) and the digital
input (“DGTL AUTO”).
* “ANALOGUE” is the initial setting.
TO BE CONTINUED TO THE NEXT PAGE
Source selecting buttons
(DVD, STB, TV)
INPUT
ANALOG/DIGITAL
SETTING
Basic Settings
VOL
SETTING
ANALOG
PR ΙΙ
SUBWFRLFE
VOL
AUTO SR
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
(back to the beginning)
STB VCR TV
DVD
Remote
NOT
STB VCR TV TAPE
FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST
SETTING
STANDBY
INPUT
ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND
ON/OFF
SURROUND
MODE
ANALOG
PL ΙΙ
SUBWFRLFE
SLEEP MODE TA
STTUNEDINFO
HEWS
AUTO MUTING
MH
Z
KHZ
VOL
AUTO
AUTO SR
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
PHONES
RDS
HP
CONTROL
5/∞/3/2
Display
CONTROL
CONTROL
ANALOG
SUBWFR
LR
DOLBY D
DOLBY D
INPUT
ANALOG/DIGITAL
INPUT ATT
EN10-19.RX-E111&112RSL[B]_f 02.1.17, 9:18 AM13