Filter
Top Products
9
Getting Started
For an analogue decoder
To watch or record a scrambled program on
your VCR, connect the analogue decoder to
your VCR and select the scrambled channel
on your VCR.
If there is not an appropriate terminal for the
decoder on your VCR, connect the decoder
to your TV.
Refer also to the manuals supplied with
these equipments.
Connecting the Power Cord
Before plugging the power cord into an AC outlet, make sure that all
connections have been made.
Plug the power cord into an AC outlet.
Keep the power cord away from the connecting cables and the
antenna. The power cord may cause noise or screen interference. We
recommend that you use a coaxial cable to connect the antenna,
since it is well-shielded against interference.
Note:
The preset settings such as preset channels and sound adjustment
may be erased in a few days in the following cases:
– When you unplug the power cord.
– When a power failure occurs.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to damage
the cord.
When the TV is equipped with the plural SCART terminals, refer
to the manual supplied with the TV to check the available video
signals for each terminal, then connect SCART cable correctly.
For TV and video format
This unit cannot convert the video signals (S-video or
Composite). When the video signal of one video component is
different from that of the other (for example, one is
S-video, the other is Composite), you may not see the pictures
appropriately. In this case, unify the video signals of all the
video components into S-video or Composite, or you need to
switch the video signal of TV each time you change the source.
For recording pictures from STB
When you connect a STB and a VCR
directly with a SCART cable, you can enjoy
recording the pictures from the STB onto
VCR without using menu screens of STB.
For details, refer also to the manuals
supplied with the STB.
For digital sounds
• To enjoy the DVD software encoded with
Dolby Digital or DTS Digital Surround,
connect the DVD player using one of the
DIGITAL IN terminals (see page 7).
• To enjoy the digital sounds, use both the
SCART cable connection and the digital
connection (see page 7).
For T-V LINK
• You can use T-V LINK function if you connect the T-V LINK
compatible TV and VCR to this unit with a fully wired SCART
cables. For details on T-V LINK, refer also to the manuals
supplied with the TV and the VCR.
• Connect SCART cable to EXT-2 terminal on your JVC’s T-V
LINK compatible TV for T-V LINK function.
• Some TV, VCR, STB and DVD player support this type of
data communication. For complete details, refer also to the
manuals supplied with these equipments.
DVD Player
STANDBY
STANDBY ON
DOLBY
D
I
G
I
T
A
L
TV
VCR
STB
EN01-09.RX-E111&112R[B]_f 02.2.6, 7:31 PM9