Filter
Top Products
9
Connecting the System
The antenna supplied with the system is a basic antenna for indoor use. For stable signal
reception, the use of an outdoor antenna (commercially available) is recommended. To
connect an outdoor antenna, first remove the indoor antenna.
Connecting the FM indoor antenna
Preparing the ends of the speaker cords
Twist the plastic sleeve on the end of the cord as
you pull it off.
l
Notes on connecting the
speaker cords
Never short-circuit the positive (+) and negative (–) ends
of the speaker cords. (Do not touch the + and - cords
together.) Mistakenly reversing the positive and negative
polarity will result in unnatural sound and unclear sound.
Connecting the speakers
Microcomputer malfunctions
If the system is connected correctly and still does not
operate normally or shows display errors, reset the
microcomputer. (P.67)
The antenna supplied with the system is for indoor use. Place it as far as possible away from
the main unit, your TV set, the speaker cords and the power cord and point it in the direction
that gives the best reception.
Connecting the AM loop antenna
123
Connecting the antenna cord
As shown on the right, connect the AM
antenna cord [AM] terminals.
l
1234
Connecting the speaker cords to the speaker
l
Connecting the speaker cords to the main unit
l
UX-J51_EN.indb 9UX-J51_EN.indb 9 10.8.19 2:50:47 PM10.8.19 2:50:47 PM