Filter
Top Products
60
Set the system clock to the correct time. If the system clock time setting is not correct, the Program Timer
will not start playback at the correct time.
Setting the System Clock
Set the time.
*4*4
Select “TIME ADJUST”.
Press the [
C
] or [
D
] key.
22
Set the day of the week.
Press the [
A
] or [
B
] key.
*3*3
Use the [
A
] or [
B
] key to set the “hour”.
Use the [
A
] or [
B
] key to set the “minute”.
Press the [ENTER] key.
Press the [ENTER] key.
The currently set day of the week and time are displayed.
l
If you make a mistake, repeat the procedure from the beginning.
If there is a power failure or the system is unplugged from the wall
outlet for some time, set the time again.
Pressing the [
F
] key on the remote control while the system is in the
Standby mode will display the time for 5 seconds.
l
l
l
Press the [ENTER] key.
Press the [ENTER] key.
Press the [MODE] key.
11
* On step 3 and 4,
clock display shown
is di erent for U.S.A.
and Canada.
UX-J51_EN.indb 60UX-J51_EN.indb 60 10.8.19 2:51:11 PM10.8.19 2:51:11 PM