Filter
Top Products
15
Loading the remote control batteries
1
Remove the
battery cover.
2
Load the AAA-size batteries
supplied with the system.
3
Close the
battery cover.
Check the polarity of
the batteries (
UV
)
when loading them.
l
The batteries supplied with the system are for operational testing and may last only for a short time.
When replacing the batteries, always load 2 new batteries.
l
l
Component Names and Functions
Using the remote control
After plugging the main unit into an AC
wall outlet, press the power [ ] key
on the remote control unit to turn the
system on.
After the system powers up, press the
key for the function you want to use.
Point the remote control at the remote
sensor when using it.
The remote control may not operate
correctly if direct sunlight or light
from a high-frequency fluorescent
lamp (such as an inverter type) is
shining on the remote sensor. If
this happens, move the system to a
different location to avoid this type
of malfunction.
l
Approx.
6 m
(19.68 ft.)
Approx.
30
°
Approx.
30
°
CAUTION
Do not leave the battery near fire or under direct sunlight. A fire, explosion
or excessive heat generation may result.
If the range or effectiveness of
the remote control decreases,
replace both batteries.
l
UX-J51_EN.indb 15UX-J51_EN.indb 15 10.8.19 2:50:51 PM10.8.19 2:50:51 PM