Filter
Top Products
8
Index parts and facilities
Front panel
For further operational instructions, see the pages indicated in
brackets [ ].
Standby/On button [28]
If pressed with the receiver plugged in, the DTR-7.3 turns on and the
display lights up. If pressed again, the DTR-7.3 returns to the
standby state. In the standby state, the display is turned off and the
DTR-7.3 cannot be operated.
Standby indicator [7, 28]
Lights when the DTR-7.3 is in the standby state and when a signal is
received from the remote controller.
Audio Selector button [33]
Press to select the type of audio input signal.
Remote control sensor [7]
Display button [32]
Press to display information about the current input source signal.
Each time you press the display button, the screen changes to show
you different information concerning the input signal.
Dimmer button [32]
Press to set the brightness of the front display. There are three
settings available: normal, dark, and very dark.
• The brightness of the front display can also be performed using
the remote controller.
Listening mode buttons [31, 51]
Press these buttons to select a listening mode for the current input
source.
Direct/Pure Audio: Press to switch between the direct and pure
audio listening modes.
Stereo: Selects for the stereo listening mode.
Surround: Selects for the Dolby Pro LogicII, DTS Neo:6, Dolby
Digital, or DTS listening modes.
THX: Selects for the THX listening mode.
DSP
/ : Switches to the DSP mode.
Front display
Memory button [35]
Press to assign the radio station that you are currently tuned into to a
preset channel or press to delete a previously preset station.
FM Mode button [34]
Press to change the stereo mode from AUTO to MONO and vice
versa. Each time this button is pressed, the AUTO indication turns
on and off indicating the current mode. If you are listening to an FM
radio station in stereo and the sound cuts out or there is a great deal of
noise, switch from AUTO to MONO.
Tuning / , Preset / , cursor buttons [34, 35, 40]
To tune into a radio station, press the Tuning / buttons. The tuner
frequency is displayed in the front display and it can be changed in
100-kHz (or 50-kHz) increments for FM and 10-kHz (or 9-kHz)
increments for AM.