Filter
Top Products
61
Using remote controller
Overview
The RC-514M remote controller is a useful tool that can not only
operate the DTR-7.3, but also all the other components of your home
theater as well. To operate any component, first press the Mode
button on the remote controller that corresponds to the component
that you wish to control. Then simply press the desired operation
button and the component will operate accordingly.
To operate a satellite, tuner, cable, VCR, or television with the
remote controller, first program the signal to the button.
There are two methods. One method is selecting the name of a
different brand from the table, entering the setting number listed, and
calling up the pre-programming code (see page 65). The other
method is sending the commands from the other brand’s remote
control directly into this remote controller (see page 69).
Controlling an Integra/Onkyo cassette tape deck
The connector of the Integra/Onkyo cassette tape deck must be
connected to the DTR-7.3 (see page 26).
1. Press the RCVR Mode button.
The RCVR Mode button lights.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Integra/Onkyo cassette
tape deck.
Operation buttons:
: Play
: Stop
: Rewind
: Fast forward
: Skips to beginning of next track during playback
: Skips to beginning of current track during playback
Rec ●: Record/Pause
: Reverse playback
You may also use the following buttons:
VOL : Adjusts volume at DTR-7.3
Muting: Activates muting function at DTR-7.3
Note:
Even for devices with the and buttons, signal discrepancies
may cause them not to work properly.
Muting
VOL
RCVR Mode
TAPE
operation
buttons