Filter
Top Products
41
0. Hardware Setup Menu
The settings within the Hardware Setup Menu will need to be made
before you use your DTR-7.3 for the first time. Once you set the
Speaker Impedance setting of the Hardware Setup Menu, the setting
will not be displayed again when you enter the Basic Menu. To
change the setting at a later date, select the Advanced Menu to
display the Hardware Setup Menu.
0-1. Speaker Impedance Sub-menu
Use this sub-menu to set the impedance level of the DTR-7.3 to
match the specifications of the speakers you are using.
If the impedances of all speakers are between 6 and 16 Ω, select “6
ohms.” If the impedance of even one speaker is between 4 and 6 Ω,
select “4 ohms.”
Note:
Before you change this setting, be sure to first lower the volume at
the DTR-7.3 to the minimum level.
Advanced Menu
0.Hardware Setup
1.Speaker Impedance
2.Surr Back/Zone2
3.IR IN Setup
|ENTER|Quit:|SETUP|
0-2. Surr Back/Zone 2 Sub-menu
a. Surr Back/Zone 2
Zone 2: Select when connecting the speakers for the remote
zone (Zone 2) to the SURR BACK/ZONE 2 PRE OUT or SURR
BACK/ZONE 2 SPEAKERS terminals (for using the internal
amplifier for Zone 2).
Surr Back: Select when connecting the speakers for the Surr
Back to the SURR BACK/ZONE 2 PRE OUT or SURR BACK/
ZONE 2 SPEAKERS terminals (for using the internal amplifier
for the surround back speakers).
Note:
The SURR BACK/ZONE 2 PRE OUT and SURR BACK/ZONE
2 SPEAKER terminals
In order to have 7.1-channel playback in the main room, you must set
the Surr Back/Zone 2 setting to “Surr Back.” When set to “Surr
Back,” the surround back signals are output from the SURR BACK/
ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER
terminals. Connect the surround back speakers to the SURR BACK/
ZONE 2 SPEAKER terminals or to the speakers terminals of the
power amplifier connected to the SURR BACK/ZONE 2 PRE OUT
terminals.
When you are not using the surround back speakers in the main room
and using the internal amplifier to power the speakers for the remote
zone (Zone 2), set the Surr Back/Zone 2 setting to “Zone 2.” When
set to “Zone 2,” the Zone 2 signals are output from the SURR
BACK/ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER
terminals. Connect the remote zone (Zone 2) speakers to the SURR
BACK/ZONE 2 SPEAKER terminals or to the speakers terminals of
the power amplifier connected to the SURR BACK/ZONE 2 PRE
OUT terminals.
At this time, the main room is switched to 5.1 channel playback
mode, and therefore you cannot select the THX Surround EX or
DTS-ES, which requires the sound back.
Hardware Setup
Advanced Menu
0.Hardware Setup
0-1.Speaker Impedance
a.Minimum :6 ohms
Quit:|SETUP|
Advanced Menu
0.Hardware Setup
0-2.Surr Back/Zone2
a.Surr Back/Zone2
:Surr Back
Quit:|SETUP|