Filter
Top Products
55
Using a Macro function
Macro Direct Learning function
A series of remote controller button operations can be memorized
into the MACRO DIRECT button for one-touch control.
Note:
You can program only one series of button operations into the
MACRO DIRECT button.
1. Press and hold down any one of the eight MODE buttons
and press the MACRO DIRECT button. Then, release the
buttons.
When you press the MODE button, the SEND/LEARN indica-
tor lights up. When you press the MACRO DIRECT button, the
indicator turns off. When you release the buttons, the indicator
flashes briefly, then lights up again.
2. Follow Step 2 in the “Programming Macro Mode” on page
54.
3. Press the MACRO DIRECT button to complete the proce-
dure.
The SEND/LEARN indicator flashes twice slowly.
4. Check to see if the button has been programmed correctly.
Point the RC-392M toward the receiver and press the MACRO
DIRECT button, and make sure that the device responds as pro-
grammed.
Transmitting the codes in Macro mode takes a while. During
transmission, point the remote controller toward the device to be
controlled.
Notes:
• You may program up to 16 button operations into the MACRO DI-
RECT button. If you try to program the 17th step, it will be ignored.
• If you do not press any button for more than 30 seconds during the pro-
cedure, the SEND/LEARN indicator flashes three times quickly, then
the RC-392M exits Learning mode. Resume from Step 1.
• If you make a mistake during programming, the SEND/LEARN indica-
tor flashes three times quickly, then the RC-392M exits Learning mode.
Resume from Step 1.
• If you cancel one of the operation already programmed in the MACRO
DIRECT button, or if you program a different code into such a button,
the operation button will no longer work. In this case, program the but-
tons again to avoid malfunction.
Tip:
The codes programmed into a MACRO
button will be transmitted with an interval
of 0.5 seconds. However, some devices
may not be able to complete one operation
in 0.5 seconds and may miss the next
code. In this case, press one operation
button, press the corresponding MODE
button, then press another operation but-
ton to extend the interval between the two
operations up to one second.
1, 3
1