Filter
Top Products
23
PRESET/MODE ADJ
PUSH TO ENTER
PRESET/MODE ADJ
PUSH TO ENTER
• Using the on-screen display
1. Press the OSD MENU button.
2. Select “Speaker Setup” and then press the right edge of the
ENTER/Cursor button.
3. Select “Bass Peak Setup” and then press the right edge of the
ENTER/Cursor button.
The “Bass Peak Setup” screen appears.
Bass Peak Level Limiter :
Enables (Yes) / Disables (No) the bass peak limiter.
The Peak Level indicates the bass peak level when the limiter
is set to Yes.
4. Select “Starting The Test Tone” and then press the right
edge of the ENTER/Cursor button.
This generates a test signal and automatically sets the unit's
MASTER VOLUME control knob to -27 dB.
You can now press the right and left edges of the ENTER/Cur-
sor button to adjust the peak level in units of 1 dB.
5. Press the ENTER/Cursor button just before the sound is dis-
torted.
The bass peak level is stored and the Speaker Setup screen is
displayed again.
Setting the Speaker level
Playing a digital source (Digital Input Setup)
SPEAKERS
A PCM DIGITAL
DIRECT
STEREO
3
4
* Bass Peak Setup *
Bass Peak Level
Limiter = Yes
Peak Level =+18dB
Starting
The Test Tone
* Bass Peak Setup *
1.Turn Volume Up.
2.When Sound Distorts.
3.Press ENTER.
Level -31dB
Digital input setup
Each of the DVD, CD, VIDEO 1-3, and TAPE input channels can be
set so that it accepts analog or digital audio input. The default setting
is below. Change the setting according to the connection.
DVD: OPT2
VIDEO1: COAX1
VIDEO2: – – – –
VIDEO3: COAX2
TAPE: – – – –
CD: OPT1
Assume that you have connected a DVD player to the COAXIAL 1
connector.
1. Press the DVD input selector button.
2. Press the DIGITAL/ANALOG button until "Digital In-
put?" appears.
3. Press the SMART SCAN CONTROLLER.
The digital input setup mode has been set.
By rotating the SMART SCAN CONTROLLER, select the digi-
tal audio input connector “COAX 1,” from among “OPT 1,”
“OPT 2,” “COAX 1,” “COAX 2” and “– – – – .” Selecting
“– – – –”sets analog audio input.
4. Press the SMART SCAN CONTROLLER.
This completes the digital input setup.
DIGITAL/
ANALOG
2
3
To select an input source using the on-screen display, follow steps 1
through 3 described on page 29.