Filter
Top Products
31
Selecting an input source
Falling asleep with music (Sleep function,
remote controller only)
You can turn off the power to the DTR-7/DTR-6 automatically after
a specified time period.
1. Press the MODE AUDIO button.
2. Press the SLEEP button.
The display shows “Sleep 90min,” which means the receiver
automatically enters the standby mode after 90 minutes.
3. Press the SLEEP button repeatedly until the desired sleep
time is displayed.
Each time you press this button, the time decreases by 10 minutes.
To check how much time is left before the unit turns off...
Press the SLEEP button when the Sleep function is enabled.
Note:
Pressing the SLEEP button when the Sleep time display shows 10
minutes or less cancels the Sleep function.
Adjusting the tone (Bass and treble adjustment)
The bass and treble levels can be adjusted in the range of +/-12 in
units of 2.
You cannot perform this adjustment when the listening mode is
“THX” or “Direct.”
1. Press the BASS/TREBLE button.
The display shows "Bass=."
Rotate the SMART SCAN CONTROLLER to adjust the bass
level.
2. Press the SMART SCAN CONTROLLER.
The display shows "Treble=."
Rotate the SMART SCAN CONTROLLER to adjust the treble
level.
3. Press the SMART SCAN CONTROLLER.
• Adjusting the bass and treble levels with the on-
screen display
1. Press the OSD MENU button.
2. Select "Listening mode Setup" and then press the right edge
of the ENTER/Cursor button.
3. Select "Listening Mode" and then press the right edge of the
ENTER/Cursor button
4. Select "Tone Control" and then press the right edge of the
ENTER/Cursor button.
The "Tone Control Setup" screen appears.
Press the upper or lower edge of the ENTER/Cursor button to
select "Bass" or "Treble" and then press the right or left edge of
the button to adjust the bass or treble level.
Select “Set to Flat” and then press the right edge of the ENTER/
Cursor button to restore the “flat” bass and treble sound.
5. Press the center of the ENTER/Cursor button, or press the
EXIT button, to exit the setup mode.
Note:
You cannot perform this adjustment when the listening mode is “Di-
rect” or “THX (DTR-7 only).”
4
* Tone Control *
Bass = 0
Treble = +2
Set To Flat
BASS/
TREBLE
Remote controller
SPEAKERS
A
SLEEP
AUTO
STEREO
Muting the sound (Muting function, remote
controller only)
Use this function to turn off the playback sound immediately. For
example, you can use it when you receive a phone call when listen-
ing to music.
Press the MUTING button.
The display shows "Muting." Now the sound output to the speakers
and headphones stops.
Press the MUTING button again to turn on the sound output.
Note:
The Muting function will be canceled automatically if the receiver is
set in the standby mode.
Remote controller