Filter
Top Products
Menu System
37
CDR-882 User Manual Version 1.0 www.hhb.co.uk
General Submenu
The General submenu has two settings available for adjustment.
Timer
The CDR-882 has a Timer function which, when enabled, causes
the CDR-882 to enter PLAY mode when the power is applied.
Thus, by leaving the (mechanically-latching) power switch ON, the
CDR-882 can be used to start playing a pre-loaded disc (or
discs) when external power is applied via a time-controlled switch
of some description.
The submenu option can simply be set to On or Off. The factory
default setting is Off.
With the Timer function enabled, the CDR-882 first goes
through its usual power-up diagnostic routines when power is
applied. The drive containing an audio disc then enters PLAY
mode; if both drives have discs, that in Drive 1 will be played.
The CDR-882 also restores its MODE setting at the last power-
down - i.e. Single, DualBurn or DiscSpan. Thus if DiscSpan mode
is set, discs in the two drives will play in sequence.
Eject Block
The EJECT function is disabled if the selected drive is in either
RECORD or RECORD PAUSE mode, to prevent inadvertent disc
ejection and consequent recording abort. It is possible to
additionally disable EJECT from all modes other than STOP,
thereby guarding against the possibility of a disc being ejected
while it is playing.
The submenu option can simply be set to On or Off. With the
option set to Off, EJECT is only disabled in RECORD and RECORD
PAUSE modes. When On, the selected drive must be in STOP
mode for the EJECT function to work. The factory default setting
is Off.
Firmware Submenu
The Firmware submenu displays the version numbers of the
various firmware files within the CDR-882. The user need not
concern him/herself with these, but they may be useful to
HHB’s Technical Support engineers should a problem arise with
the unit.
No adjustments are available within this submenu.
CDR882 Firmware Version
Displays the version number of the CDR-882’s main operating
system, and date.
Drive 1 Firmware Version
Displays the version number of Drive 1’s internal firmware.
Drive 2 Firmware Version
Displays the version number of Drive 2’s internal firmware.
CPLD Firmware Version
Displays the version number of the CDR-882’s Complex
Programmable Logic Device.