Harman-Kardon 950-0321-001 Home Theater System User Manual


 
BDS
5
ENGLISH
Receiver Front-Panel Controls
Disc Slot: Insert a compatible disc into the slot. The BDS receiver’s disc player will accept
5-inch (12cm) and 3-inch (8cm) discs.
Information Display: Various messages appear on this display in response to commands
and to show the audio/video that is playing, the settings or other aspects of the BDS receiver’s
status as described throughout this manual.
Eject Button (on top of unit): Press this button to eject a disc from the BDS receiver’s
built-in disc player. Before pressing this button, make sure no objects are blocking the
disc-slot opening. NOTE: If you do not remove the ejected disc within 90 seconds, it will
automatically re-load back into the disc player for protection.
Standby Button (on top of unit): This button toggles the receiver between the On and
Standby modes.
Power Indicator: This LED surrounds the Standby button. When the BDS receiver is
plugged into AC power, the LED turns amber to indicate that the receiver is in Standby mode
(ready to be turned on). When you turn the BDS receiver on (by the Standby button or the
remote control’s Power button), the LED turns white.
Headphone Jack: Insert the 3.5mm stereo mini connector from a set of headphones into
this jack. NOTE: When a plug is inserted into the Headphone jack, the BDS receiver’s speaker
outputs automatically mute; the HDMI audio output remains active.
Volume Control: Rotate the disc clockwise to raise the volume; rotate counterclockwise
to lower the volume. The volume level will appear on the Information Display and on the
on-screen menu.
IMPORTANT: Do not turn the receiver’s Volume control up to or past the point where the audio
from the speakers becomes distorted. Doing so can damage the speakers.
USB 2.0 Port: Gently insert a flash drive or HDD disk drive with a USB Standard-A cable to
this port.
IMPORTANT: Do not connect a PC or other USB host/controller to this port, or
you may damage both the BDS receiver and the other device.
Orient the device’s plug so it fits all the way into the BDS receiver’s USB connector. You may
insert or remove the device at any time – there is no installation or ejection procedure.
Receiver Front-Panel Controls
Disc Slot Information Display
Headphone Jack
Volume Control
Eject Button (on top panel) Standby Button (on top panel)
USB Port