Filter
Top Products
CHOOSING THE PROCESSING CURVE ENG
Page 49
15 CHOOSING THE PROCESSING CURVE
15.1 INTRODUCTION
Once you have adjusted the input levels and reached the correct AGC level
, you may move on to select the
processing curve.
There are 30 factory presets designed for various programming formats. Chose one that approximately matches
your station’s format. If you are not sure, chose Preset # 25 and 26 to achieve best results for density, richness
and colour of the sound.
As shown in the table on the next page, there are 3 parameters involved in the audio processing. The curves may
be gather into groups: curves from 1 to 10 have a low density, curves from 11 to 20 have a medium density
and curves from 21 o 30 have a high density (i.e. they allow you to reach a high broadcasting sound level and
an average sound fidelity).
Furthermore, curves 1, 11 and 21 are totally ‘flat’: You may compare the different curves if desired, using these
curves as a reference.
NOTE - Contrary to the submenu parameters, a new curve becomes operative (thus is broadcast) only
when it is selected
via encoder and then confirmed by the ENTER command within 10 seconds after
selection.