Filter
Top Products
IN & OUT SETTINGS (FM VERSION) ENG
Page 31
12.3.6 NOISE GATE SETTING (Noise Gate)
The Mpx Module Setup / Noise Gate function allows you to avoid the effects of background noises while the
input signal presents a lack of high frequencies. The parameter to be set is the Noise Gate Threshold, which
determines the threshold value below which the dynamic pre-emphasis is automatically excluded.
The Noise Gate Threshold: This may be adjusted within a range of –80 to –51dB (1 dB steps).
The Noise Gate function can be turned off if necessary by turning the shuttle counter-clockwise to the Off
position.
12.3.7 BYPASS MODE
In Processor ByPass mode, all the processing stages are disabled (AGC system, audio processing and pre-
emphasis circuit). It allows you to carry out tests and reference measurements: it is not intended for equipment
setup or installation use