Filter
Top Products
48
3
Select the play mode.
STEREO
(Main unit) (Remote control unit)
Example: Stereo
4
Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
5
Adjust the volume.
MASTER VOLUME
(Main unit) (Remote control unit)The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –70 to 0
to 18 dB, in steps of 1 dB. However, when the channel
level is set as described on page 23 or page 56, if the
volume for any channel is set at +1 dB or greater, the
volume cannot be adjusted up to 18 dB. (In this case the
maximum volume adjustment range is “18 dB —
(Maximum value of channel level)”.)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “AUTO” or “DTS”.
Input mode display
ANALOG
ANALOG
DIGITAL
DIGITAL
AUTO
PCM
DTS
INPUT MODE
AUTO
PCM
DTS
INPUT MODE
AUTO
PCM
DTS
INPUT MODE
AUTO
PCM
DTS
INPUT MODE
DIGITAL
• In the AUTO mode
• In the PCM mode
• In the DTS mode
• In the ANALOG mode
Input signal display
DIGITAL
SIGNAL
PURE
DIRECT
DIGITAL
DIGITAL
SIGNAL
PURE
DIRECT
PURE
DIRECT
DIGITAL
SIGNAL
DIGITAL
DIGITAL
PRO LOGIC
• DOLBY DIGITAL
• DTS
This lights, depending on the input signal.
The indicator lights when digital signals are being input
properly. If the indicator does not light, check whether
the digital input component setup (page 28) and connections are
correct and whether the component’s power is turned on.
DIGITAL
DIGITAL
NOTE:
• The indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
DIGITAL
One of these lights, depending on the
input signal.