Filter
Top Products
Tuner Information
This sets the time the on-screen display is displayed when an operation
is performed.
[Selectable items]
Always
: Show display continuously.
30sec
: Show display for 30 seconds after operation.
10sec
: Show display for 10 seconds after operation.
OFF
: Turn display off.
Display Mode
Select the on-screen display's display mode.
[Selectable items]
Mode1
: If there is no video signal, flickering of the on-screen display
is not prevented.
Mode2
: Prevents flickering of the on-screen display when there is
no video signal.
Use this mode if the on-screen display does not appear
in the Mode 1, as may happen according to the TV being
used.
g
Quick Select Name
Change the Quick Select name.
Up to 16 characters can be input.
[Input characters]
A ~ Z
a ~ z
0 ~ 9
! # % & ’ ( ) * + , - . / : ; = “ ? @ [ \ ] (space)
h
Trigger Out
Select the conditions to turn on the trigger out with respect to the
zone, input source, surround mode. For details about the trigger
out function, see page 19.
iPod Information
This sets the time the on-screen display is displayed when an operation
is performed.
[Selectable items]
Always
: Show display continuously.
30sec
: Show display for 30 seconds after operation.
10sec
: Show display for 10 seconds after operation.
OFF
: Turn display off.
j
Remote ID Setup
Set remote control ID.
Match the ID setting of the remote control unit and the receiver.
When changing the remote ID, also change the AMP, iPod and TU
modes of the main remote control unit at the same time (vpage
54).
k
2Way Remote
Make setting for 2-way remote control unit.
[Selectable items]
1
2
3
4
:
Match the ID setting of the remote control and the receiver.
[Selectable items]
Used
: Use 2-way remote control.
Not Used
: Do not use 2-way remote control.
When using a 2-way remote control unit (RC-7000CI and RC-7001RCI,
sold separately), set this to “Used”.
l
Display
Adjust display brightness of the receiver.
Operating from the main unit
Press the DIMMER button.
Bright Dim
DarkOFF
[Selectable items]
Bright
: Normal display brightness.
Dim
: Reduced display brightness.
Dark
: Very low display brightness.
OFF
: Display is off unless controls are operated.
Setting with Respect to the Input Source
When the input source set to on is selected, the trigger out turns on.
Setting with Respect to the Surround Mode
• When the surround mode set to on is selected, the trigger out turns
on.
• Associated with respect to surround modes that are set to “ON”.
• This can be set if the “MAIN ZONE” is selected at “Selecting the
Zone”.
• Associated when an input source for which “Setting with Respect to
the Input Source” is set to “ON” is selected.
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
Select “Trigger Out 1” or “Trigger Out 2” and make the settings below
respectively.
Selecting the Zone
Select the zone for which the trigger out is set.
[Selectable items]
ON
: Activate trigger on this mode.
– – –
: Do not activate trigger on this mode.