Filter
Top Products
Error Messages
If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is
displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over
again.
Error messages (examples) Cause Measures
or
Retry
Cancel
Microphone:None
Speaker :None
Auto Setup
Audyssey
MultEQ XT
Caution!
• Included setup microphone is not connected.
• Not all speakers could be detected.
• Connect the included setup microphone to the SETUP
MIC jack on the main unit.
• Check the speaker connections.
too high or
Retry
Cancel
Ambient noise is
Level is too low.
Auto Setup
Audyssey
MultEQ XT
Caution!
• Too much noise in the room for accurate
measurements to be made.
• Speaker or subwoofer sound is too low for
accurate measurements to be made.
• Either turn off any device generating noise or move it
away.
• Try again when the surroundings are quieter.
• Check the speaker installation and the direction in
which the speakers are facing.
• Adjust the subwoofer’s volume.
Retry
R :None
Cancel
Front
Auto Setup
Caution!
Audyssey
MultEQ XT
• Displayed speaker could not be detected.
· The front L and front R speakers were not
properly detected.
· Only one channel of the surround speakers
was detected.
· Sound was output from the R channel
when only one surround back speaker was
connected.
· The surround back speaker was detected,
but the surround speaker was not detected.
• Check the connections of the displayed speaker.
Retry
L :Phase
Cancel
Skip
Front
Auto Setup
Caution!
Audyssey
MultEQ XT
• Displayed speaker connected with the
polarities reversed.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected. If
you are sure that the wiring is correct, select “Skip”.
NOTE
Be sure to turn the power off before checking the speaker connections.
Room EQ
Select room EQ setting method.
[Selectable items]
All
: Apply settings to all surround modes.
Assign
: Make settings for each surround mode separately.
s
Option
Select settings for room EQ, mic, etc.
Select “Retry” to make the measurements again.
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
Direct Mode Setup
Select room EQ use for DIRECT or PURE DIRECT mode.
[Selectable items]
ON
: Use room EQ.
OFF
: Do not use room EQ.
Mic Select
Select the microphone type if not using supplied mic.
The microphone connected to V.AUX Lch is used.
[Selectable items]
Mic
: Supplied mic is being used.
V.AUX L
: Other mic connected to V.AUX is used.
d
Parameter Check
Check auto setup measurement results.
This is displayed after the auto setup procedure is completed.
The auto setup results can be reset to what was originally calculated
by MultEQ XT when “Restore” is selected.
Only a professionally certified installer should ever connect a
professionally-calibrated microphone to the V.AUX L input on the front
panel.
[Items to be checked]
Speaker Config. Check
Distance Check
Channel Level Check
Crossover Freq. Check
EQ Check