Filter
Top Products
Remote Control Unit Operations
Main Remote Control Unit
• On the main remote control unit, the display switches according
to the device being operated and the mode.
• In modes other than iPod, the mode switches between“ ”
and “ ” each time the [MODE SELECTOR] is pressed.
• In the AMP, TUNER, NET/DTU and iPod modes, when the remote
ID is set, the AVR-5308CI can be used independently even in an
environment containing multiple DENON amplifiers.
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
NOTE
The device mode (“ ” or “ ”) cannot be changed while the
setting is being made.
Operating DENON Audio Components
1
Press [MODE SELECTOR] for the component to be
operated.
The indicator for the component to be operated flashes.
: AMP / ZONE2 / ZONE3 / ZONE4 /
SYSTEM CALL
: TUNER (FM/AM) / XM
: NETWORK/USB /
DIGITAL TUNER (HD Radio)
: Satellite Receiver / Cable TV
: iPod
: DVD player (recorder) /
CD player (recorder)
: VCR / TAPE
: TV
b The mode switches each time [AMP] is pressed.
G
AMP modeH GZONE2 modeH GZONE3 modeH
GSYSTEM CALL modeH GZONE4 modeH
2
Operate the component.
b For details, refer to the component’s operating instructions.
Presetting
The included main remote control unit can be preset to operate
devices of various brands.
1
Press [MODE SELECTOR] for the device you want to
preset.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Press [NUMBER] and input the 5-digit number of the
brand of the component to be preset. The numbers
are shown in the Preset Code Table (vEnd of this
manual).
When the code is registered, the signal transmission indicator
flashes twice.
When the preset code is transmitted, the mode indicator for the
component to which that code belongs flashes.
b The input mode is canceled if no button is operated for 10
seconds.
Some brands have more than one preset code. If the component does
not operate, try inputting a different code.
Operating Preset Components
1
Press [MODE SELECTOR] for the component to be
operated.
The mode indicator of the device to be operated flashes.
2
Operate the component.
b For details, refer to the component’s operating instructions.
[NUMBER]
[MODE SELECTOR]
[RC SETUP]
[HOME]
[ AMP]
Signal transmission
indicator
[HOME] is used to return to the AMP mode (AMP, ZONE2, ZONE3,
ZONE4 or SYSTEM CALL) when in any mode other than AMP.
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
AVR5308CIEU_100_初校作成中.indd 76 2008/05/26 9:42:56