Filter
Top Products
Getting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting
Multi Zone
ZONE2 or ZONE3 Pre-out Connections
• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 or ZONE3 pre-out
(variable or fixed level) connectors can be used to play a different program source in ZONE2 or ZONE3
the same time (vpage 85 ~ 90).
• When using a component video cable to connect the AVR-5308CI and input device, connect the ZONE2
monitor output to the component video connectors. When using an S-Video cable, connect the cable
to the S-Video or the video connectors. When using a video cable, connect the cable to the video
connectors.
• The ZONE2 (ZONE3) video out is only for ZONE2 (ZONE3).
R
L
R
L
"6%*0
3-
*/ */
7*%&0
"6%*0
R
L
R
L
"6%*0
3-
*/
"6%*0
7*%&0 7*%&0
*/
7*%&0
$0.10/&/57*%&0
: 1# 13
*/
47*%&0
*/
"69
065
ZONE2
Power
amplier
Input
Output
Infrared
retransmitter
Infrared
sensor
Extension jack for future use.
NOTE
• For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced.
• For instructions on installing and operating separately sold devices, refer to the respective devices’
operating instructions.
• To conduct multi-zone playback, see “Amp Assign / Multi-Zone Connections and Operations” (vpage
85 ~ 90).
Monitor
"6%*0
*/
015*$"-
"6%*0
*/
015*$"-
Monitor
Power
amplier
ZONE3
ZONE2 or ZONE4 Optical Connections
AV amplier
(ZONE2)
AV amplier
(ZONE4)
The AVR-5308CI is equipped with Optical output connectors for ZONE2 and ZONE4. If a bit-stream amp is
rigged-up, these zones can also be used to enjoy home theater.
• Connect the monitor for ZONE2 the same as the “ZONE2 or ZONE3 Pre-out Connectors”. (vSee left
column).
• If the signal inputted to ZONE2 is analog, change to PCM(2-channel) signal, and output it from ZONE2
optical output connectors.
Connections
AVR5308CIEU_100_初校作成中.indd 23 2008/05/26 9:38:48