Filter
Top Products
Getting Started Connections Setup Playback Remote Control Information Troubleshooting Specifi cations
(Main remote control unit)
(Sub remote control unit)
Multi-zone Operations
Turning the Power On and Off
GOperation on the main unitH
Press <ZONE2 ON/OFF> or <ZONE3 ON/OFF> for the zone to be
operated.
When the power turns on, the multi-zone indicator ( or )
lights on the display.
GOperation on the remote control unitH
In the zone mode you want to operate, press [ZONE2 ON], [ZONE3
ON] or [ZONE OFF], [ZONE3 OFF].
Turning off the Sound Temporarily
In the zone mode for which you want to mute the sound, press
[MUTE].
The sound is reduced to the level set at menu “Manual Setup” – “Zone
Setup” – “(select the zone)” – “Mute Level” (vpage 32).
To cancel, either adjust the volume or press [MUTE] again.
The setting is canceled when the zone’s power is turned off.
• The source selected for ZONE2 is also output from the recording
output connectors.
• When the input source to which the digital input connectors
(OPTICAL/COAXIAL) are assigned is selected in ZONE2 or ZONE3,
playback is only possible if the digital signal being input is in PCM
(2-channel) format.
NOTE
• Digital audio signals input from the HDMI connectors cannot be
played in multi-zone.
• When certain digital signals are being input, noise may be output
from the ZONE2 and ZONE3 audio output connectors.
Selecting the Input Source
GOperation on the main unitH
q Press <ZONE2/3 / REC SELECT> and select the zone to be
adjusted.
w Turn <SOURCE SELECT>.
GOperation on the remote control unitH
In the zone mode you want to operate, press [SOURCE SELECT].
Adjusting the Volume
GOperation on the main unitH
q Press <ZONE2/3 / REC SELECT> and select the zone to be
adjusted.
w Turn <VOLUME> to adjust.
GOperation on the remote control unitH
In the zone mode whose volume you want to adjust, press [VOLUME].
– – –
–70dB
~
–40dB
~
+18dB
[Variable range]
• The volume can be adjusted when menu “Manual Setup” – “Zone
Setup” – “(select the zone)” – “Volume Level” is set to “VAR”. The
volume can be increased up to the value set at menu “Manual Setup”
– “Zone Setup” – “(select the zone)” – “Volume Limit” (vpage
32).
• The volume for ZONE2 and ZONE3 can be adjusted with the remote
conrol unit.
• Also press [SOURCE SELECT] when in standby mode, the power
turns on.
• When using ZONE2 or ZONE3, it is possible to turn the power for the
MAIN ZONE only on or off by pressing [MAIN ZONE ON] or [MAIN
ZONE OFF].
<ZONE2 ON/OFF>
VOLUMESOURCE SELECT
<ZONE3 ON/OFF>
<ZONE2/3 / REC SELECT>
[ZONE3 ON]
[ZONE3 OFF]
[POWER OFF]
SOURCE SELECT
[POWER ON]
VOLUME
[MUTE]
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
SOURCE
SELECT
[MAIN ZONE ON],
[MAIN ZONE OFF]
VOLUME
[MUTE]
[ZONE2 ON]
[ZONE2 OFF]
[ AMP]
Multi-zone