Filter
Top Products
Getting Started Connections Playback Remote Control Multi-zone Information Troubleshooting
Specifi cations
Parameter
1
Press MENU.
The menu is displayed.
b To operate from the main remote control unit, be sure to set the
remote control unit to the AMP mode.
2
Press ui to select “Parameter”, then press ENTER.
3
To change the setting:
Press ui to select the item you want to change, then
press o p to change the setting.
b To return to the previous item, press RETURN.
b Select “Default Yes”, then press o to reset to the default
setting.
4
Press ENTER to enter the setting.
Adjusting the parameters
n To exit adjustment
Press MENU during adjustment.
r Stereo Playback
Selecting the mode
Select by press DIRECT/STEREO.
[Selectable items]
STEREO
:
This is the mode for playing in stereo. The tone can be adjusted.
Sound is output from the front left and right speakers and subwoofer.
Playback in the PURE DIRECT Mode
This is the mode that recreates the original sound most faithfully,
providing extremely high quality sound.
• To cancel, press PURE DIRECT again.
• When in the PURE DIRECT mode, the on-screen display is not
displayed and the display on the main unit is turned off.
• If the HDMI input connector is selected, video outputs are output in
the PURE DIRECT mode.
• The channel level and surround parameters in the PURE DIRECT
mode are the same as in the DIRECT mode.
Press PURE DIRECT.
When DIRECT/STEREO is pressed, DIRECT mode can be switched
to STEREO mode.
STANDARD
RESTORER
AUDIO DELAY
uiop
ENTER
RETURN
DYNAMIC VOLUME
MULTEQ XT
MENU
<SURROUND BACK>
STANDARD
RESTORER
AUDIO DELAY
uiop
ENTER
RETURN
DYNAMIC VOLUME
MULTEQ XT
MENU
[NIGHT]
[ AMP]
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Setup