Filter
Top Products
Getting Started Connections Setup Playback Multi-zone Information Troubleshooting Specifications
Remote Control Unit Operations
Main Remote Control Unit
(RC-1102)
• On the main remote control unit, the display switches according
to the device being operated and the mode.
• In modes other than iPod, the mode switches between“ ”
and “ ” each time the [MODE SELECTOR] is pressed.
• In the AMP, TUNER and iPod modes, when the remote ID is
set, the AVR-2809CI can be used independently even in an
environment containing multiple DENON amplifiers.
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
NOTE
The device mode (“ ” or “ ”) cannot be changed while the
setting is being made.
[MODE SELECTER]
[RC SETUP]
[NUMBER
(1 ~ 8)]
[HOME]
[ AMP]
[POWER ON],
[POWER OFF]
Signal transmission
indicator
Operating DENON Audio Components
1
Press [MODE SELECTOR] for the component to be
operated.
The indicator for the component to be operated flashes.
: AMP / ZONE2 / ZONE3 /
ZONE4 / SYSTEM CALL
: SIRIUS / XM
: TUNER (FM/AM)
: Satellite receiver / Cable TV
: iPod
: Blu-ray Disc player /
DVD player (Recorder) /
CD player (Recorder)
: VCR / TAPE
: TV
b The NET/TU ( ) mode is not used on the AVR-2809CI, so use
the learn function to store the signals (vpage 64).
b The mode switches each time [AMP] is pressed.
G
AMP modeH GZONE2 modeH GZONE3 modeH
GSYSTEM CALL modeH GZONE4 modeH
b The AVR-2809CI cannot be used in the ZONE4 mode.
2
Operate the component.
b For details, refer to the component’s operating instructions.
• [HOME] is used to return to the AMP mode (AMP, ZONE2, ZONE3,
ZONE4 or SYSTEM CALL) when in any mode other than AMP.
• In ZONE2, ZONE3 and ZONE4 modes, you can switch the main zone
power on or off by pressing [POWER ON] or [POWER OFF].
Presetting
The included main remote control unit can be preset to operate
devices of various brands.
1
Press [MODE SELECTOR] for the device you want to
preset.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Press [NUMBER (1 ~ 8)] and input the 5-digit number
of the brand of the component to be preset. The
numbers are shown in the Preset Code Table (vEnd
of this manual).
When the code is registered, the signal transmission indicator
flashes twice.
When the preset code is transmitted, the mode indicator for the
component to which that code belongs flashes.
b The input mode is canceled if no button is operated for 10
seconds.
Some brands have more than one preset code. If the component does
not operate, try inputting a different code.
Operating Preset Components
1
Press [MODE SELECTOR] for the component to be
operated.
The mode indicator of the device to be operated flashes.
2
Operate the component.
b For details, refer to the component’s operating instructions.
Remote Control