Denon AVR-2809CI Stereo System User Manual


 
0
Getting Started Playback Remote Control Multi-zone Information Troubleshooting
Specifi cations
NOTE
• Insert the AC plugs securely. Incomplete connections could cause
noise.
• Only use the AC outlets to plug in audio equipment. Do not use
them as power supplies for hairdryers or anything other than audio
equipment.
Wait until all connections have been completed before connecting the
power cord.
To household
power outlet
(AC 120 V, 60 Hz)
Power cord
(supplied)
Connecting the Power Cord
Connection to the AC outlets
• These outlets supply power to external audio
equipment.
• The power supplied from these outlets turns
on and off together with the set’s power
switch.
• Audio equipment with a total power
consumption of 120 W (1 A) can be
connected.
Turning the Power On (vpage 50)
Once Connections are
Completed
Menu Operations
With the AVR-2809CI, settings and operations for most functions can
be performed by operating while looking at the menus displayed on
the monitor screen.
1
Press MENU.
The menu is displayed.
b To operate from the main remote control unit, be sure to set the
remote control unit to the AMP mode.
2
Press ui to select the item you want to set, then
press ENTER.
3
Press ui again to select the item you want to set,
then press ENTER.
4
To change the setting:
Press ui to select the item you want to change, then
press o p to change the setting.
b To return to the previous item, press RETURN.
b Select “Default Yes”, then press o to reset to the default
setting.
5
Press ENTER to enter the setting.
6
Press MENU to fi nish.
Operations
The same operation is possible on the main unit or main remote
control unit.
When MENU is pressed, the settings made up to that point are entered
and the settings menu screen turns off.
Setup
ENTER
RETURN
uiop
MENU
uiop
ENTER
RETURN
MENU
[ AMP]
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Connections