Filter
Top Products
Getting Started Connections Setup Playback Multi-zone Information Troubleshooting
Specifications
NOTE
• When changing a setting, be sure to set the same remote ID as the
AVR-2809CI’s (vpage 34).
• When changing the AMP mode’s remote ID, also change the “SAT
TU”, “NET/TU” and “iPod” remote ID at the same time.
[MODE
SELECTOR]
[NUMBER]
[ NET/TU]
[ iPod]
[ AMP]
[RC SETUP]
[ SAT TU]
5
Point the main remote control units directly at each
other and press and hold the button on the other
device’s remote control unit that you want to learn.
Once learning is completed normally, the display lights and the
signal transmission indicator flashes twice.
b If you want to learn other buttons, repeat steps 4 and 5.
b The mode can be switched by pressing [MODE SELECTOR].
b The signal transmission indicator lights once for a long time if
learning was not possible
6
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
• With some remote control units, the signals cannot be learned or the
device will not operate properly even when the signals have been
learned. In this case, use the device’s own remote control unit.
• Learned buttons have priority over the preset memory. If you no
longer need the learned setting, reset the learning function (vpage
66).
NOTE
• [HOME] cannot be learned.
• Do not learn any remote control signals at [RC SETUP].
• The AMP, ZONE2, ZONE3, ZONE4 and SYSTEM CALL modes
cannot be learned.
Signal transmission
indicator
Setting the Remote ID
When using multiple DENON AV receivers in the same room,
make this setting so that only the desired AV receiver operates.
1
Press [AMP] to set the main remote control unit to the
AMP mode.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Refer to the table at the right, and use [NUMBER] to
input the 5-digit number corresponding to the remote
ID to be changed.
The signal transmission indicator flashes twice.
4
Press [NET/TU] (
mode), [iPod] or [SAT TU]
( /
mode) to select the mode to be set.
5
Repeat steps 2 to 4 to set the remote IDs for all
modes.
Learning Function
If your AV devices are of a brand other than DENON or if they
cannot be operated with the preset memory function, their
remote control signals can be transfered to stored in the AVR-
2809CI’s main remote control unit.
1
Press [MODE SELECTOR] for the device you want to
set.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Press [9], [7] and [5], in that order.
The signal transmission indicator flashes twice and the learning
mode is set.
4
Press the button to be set.
The main remote control unit’s display turns off.
b If a button that cannot be learned is pressed, the signal transmission
indicator lights but the signal is not learned.
Other device’s
remote control unit
AVR-2809CI’s main remote
control unit (RC-1102)
MODE
SELECTOR
Remote ID
AMP
(MAIN)
SAT TU NET/TU
iPod
(SIRIUS) (XM) (Analog
Tuner)
1
(Default)
81001 52271 52864 62863 72815
2 82001 52272 52812 62275 72816
3 83001 52273 52813 62276 72817
4
84001 52274
52814
62277 72818
Remote Control