Filter
Top Products
64
ENGLISH
ENGLISH
Operating the remote control unit Operating the remote control unit
Using the system call function
Press [SYSTEM CALL 1] for which you want to
register the operations.
• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.
Press the buttons you want to register in the
order of the operations to be performed.
Example: Press [ON].
↓↓
Press [CD] of [MODE SELECTOR].
↓↓
Press [1].
Repeat steps 3, 4 to register the desired buttons.
Registering
•A series of operations can be registered at a single button.
• This function makes it possible to for example turn the
amplifier’s power on, select the input source, turn the monitor
power’s on, turn the source device’s power on and start
playback, all by pressing a single button once.
• Up to 10 signals each can be stored at [SYSTEM CALL] (1 or 2).
• If your AV device is a brand other than DENON or if operation is
not possible using the preset memory function, the signals of a
remote control unit of that device can be stored in the AVR-
2807’s remote control unit.
• For some remote control units, it may not be possible to learn
the signals or the device may not operate properly after the
signals are learnt. In this case, use the remote control unit of
that device.
Setting the learning function
Press [USE/LEARN] with the tip of a pen etc., to
set the learn mode.
• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.
Press [MODE SELECTOR] for the device to be
operated.
• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.
•To cancel the learning function mode, press [USE/LEARN].
• If the codes could not be stored, the “LEARNED/TX” indicator
start flashing rapidly. For limited number of models, codes
cannot be stored in RC-1030.
• If [MODE SELECTOR] and the “LEARNED/TX” indicator start
flashing rapidly, this means that the memory is already full, and
the code you have just attempted to store was not stored.
To “learn” that code, first perform the resetting operation (
page 65).
Press the button to be set.
• The “LEARNED/TX” indicator stops blinking and [MODE
SELECTOR] lights.
If a button that cannot be learnt is pressed, [MODE SELECTOR]
and the “LEARNED/TX” indicator blinks.
Point the remote control units straight at each
other and press and hold in the button on the
other remote control unit to be learnt on the
AV R-2807’s remote control unit.
Other remote control unit
1
2
3
4
The AVR-2807’s remote control unit
(RC-1030)
Press [USE/LEARN].
6
2
4
Press [SYSTEM CALL] (1 or 2).
5
Operating
Press [SYSTEM CALL] (1 or 2) at which the operation
are registered.
• The stored signals are transmitted successively.
[MODE SELECTOR] and the “LEARNED/TX”
indicator lights, release the button on the other
remote control unit.
• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks
again.
Other buttons can be learnt by repeating steps 2 ~ 5.
5
Press [ON/SOURCE] and [POWER OFF] at the
same time.
• The “LEARNED/TX” indicator blinks.
1
Press [MODE SELECTOR] for the device to be
operated.
3
[POWER OFF]
1
[SYSTEM CALL]
[ ]
[USE/LEARN]
[ON/SOURCE]