Denon AVR-2807 Stereo Receiver User Manual


 
21
Connecting Other Sources Connecting Other Sources
ENGLISH
ENGLISH
For instructions on operations using the MULTI ZONE functions ( page 40, 41).
Connecting the MULTI ZONE terminals
If another pre-main (integrated) amplifier is connected, the ZONE2 out (fixed level) terminals can
be used to play a different program source in ZONE2 the same time ( page 40).
ZONE2 out connections
For the AUDIO output, use high quality pin-plug cables and wire in such a way that there is no
humming or noise.
For instructions on installation and operation of separately sold devices, refer to the devices’
operating instructions.
Monitor
(ZONE2)
S-VIDEO
IN
VIDEO
IN
AUX OUT
Premain amplifier
(ZONE2)
R
L
IN
G
F
R
L
R
L
A
+
+
Extension terminal
for future use.
Input Output
Infrared retransmitter Infrared
sensor
><>< ><><
><
><><><><
IN
(
L
) (
R
) (
L
) (
R
)
(
L
) (
R
) (
L
) (
R
)
Connection
terminal for
subwoofer
with built-in
amplifier.
Front speaker
(B)
Surround speaker
Front speaker
(A)
Subwoofer
ZONE2 Front speaker
Center speaker
When the surround back’s power amplifier is assigned to the ZONE2 output channel at “Power
Amp Assign” in the “System Setup Menu”, the surround back speaker terminals can be used
as the ZONE2 speaker out terminals ( page 54).
The connections diagram below is an example for when the surround back speaker is assigned
to the ZONE2 stereo 2 channel.
In this case, surround back speaker out can not be used for MAIN ZONE.
ZONE2 speaker out connections
ZONE2
Connecting the TRIGGER OUT jacks
Turn the DC 12 V voltage on and off for
the individual functions and surround
modes.
For details, see “Setting the Trigger Out”
( page 55).