Items Default settings Page
45
ENGLISH
ENGLISH
PageDefault settingsItems
Advanced Setup – Part 1 Advanced Setup – Part 1
5. Advanced Playback
1
2
2ch
Direct/Stereo
Auto
Surround
Mode
3
Dolby Digital
Setup
Basic
OFF
Auto Surround Mode = ON
52
53
53
4
Manual EQ
Setup
All Channels and Frequency = 0 dB
53, 54
6. Option Setup
1
Power Amp
Assign
54
S. Back
56
2
Trigger Out3
Volume
Control
55
Setup Lock
55
Vol.Limit = OFF
P. On Lev. = LAST
Mute Lev. = FULL
Trigger Out
1
ZONE = MAIN, All Surround Modes = ON
Setup Lock = OFF
Main
4
TUNER PHONO CD
CDR /
TAPE
DVD VDP TV
VCR-2DBS VCR-1 V.AUX
OFF OFF OFF OFF ON ON ON ONON ON ON
Trigger Out
2
ZONE = 2
TUNER PHONO CD
CDR /
TAPE
DVD
VDP TV
VCR-2
DBS VCR-1
V.AUX
ON ON ON ON ON ON ON ONON ON ON
Make the 2-channel direct mode and stereo mode speaker
settings.
Turn the audio compression on or off when down-mixing
Dolby Digital signals.
Set whether or not to store the surround mode last played
for the input signal.
Adjust the tone of the various speakers while listening to the
playback signals.
To suit your preference, a surround back channel’s power
amplifier can be assigned to the front channel (“Front A” or
“Front B”) for bi-amp playback, ZONE2.
This sets the volume level of output.
Use the DC12V output of the AVR-2807’s
two trigger out jacks in association with the
various input sources and surround modes.
This sets whether or not to lock the system setup settings
so that they cannot be changed.