Filter
Top Products
ENGLISH
ENGLISH
42
2 Last function memory
The various settings set when the AVR-2807’s power is switched
to standby are stored in the memory. When the power is turned
back on, the settings made when the power was switched to
standby are recalled.
About the memory functions
2 Backup memory
The various settings are stored in the memory for about 1 week,
even when the power is turned off or the power cord is
unplugged.
Switch off the unit using
<
POWER
>
.
Hold the following
<
PURE DIRECT
>
and
<
NIGHT
>
,
and press
<
POWER
>
.
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the settings are reset
to the default values.
Initialization of the microprocessor
Use the procedure described below to reset the microprocessor
if the display is abnormal or if the buttons on the main unit or the
remote control unit do not operate.
Check that the entire display is blinking with an
interval of about 1 second, and release your
fingers from the 2 buttons.
• The microprocessor will be initialized.
1
2
3
Advanced Operation Advanced Operation
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
<FUNCTION>
<NIGHT>
<ZONE2/REC SELECT>
<POWER>
<PURE DIRECT>
Recording (audio and/or video)
Press
<
ZONE2/REC SELECT
>
until “RECOUT”
appears on the display.
Use
<
FUNCTION
>
to select the source to be
recorded (audio and/or video).
• The “ ” indicator lights.
Record (the audio or video signals).
For operations, see the operating instructions of the device
from which you are recording (audio or video signals).
•To cancel, press
<
ZONE2/REC SELECT
>
and set the function to
“ZONE2”.
1
2
3
NOTE:
• When the REC OUT mode is selected, [ZONE2] and
[FUNCTION] (ZONE2) cannot be operated.
• Digital signals are not output from the analog REC OUT,
OPTICAL 3 OUT and OPTICAL 4 OUT terminals.
RECOUT
ZONE2