Denon AVR-2807 Stereo Receiver User Manual


 
59
ENGLISH
ENGLISH
Advanced Setup – Part 2 Advanced Setup – Part 2
2 Adjusting the test tone using the remote
control unit
Adjustment of the test tones using the remote control unit is
only possible in the “Auto” mode and only valid in the
STANDARD (Dolby Surround and DTS Surround) mode. The
adjusted levels are automatically stored for the different
surround modes.
Press [TEST TONE].
•Test tones are output from the different speakers.
Press [TEST TONE].
Press
FF GG
to adjust the volume.
1
2
3
Setting the Crossover Frequency
Set the frequency (Hz) below which the bass sound of the
various speakers is to be output from the subwoofer.
For speakers that are set to “Small”, frequencies under the
crossover frequency are cut before the signal is output, and the
low frequency component that was cut is output from the
subwoofer or the speakers that are set to “Large”.
Press
DD HH
to select “Crossover Frequency”, then
press ENTER.
1
Press
FF GG
to set.
40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:
Set as desired according to your speakers’ bass playback
ability.
Advanced:
The crossover frequency can be set individually for the
different speakers.
2
Press ENTER.
3
•The crossover frequency mode is valid only when subwoofer is
set to “ON”, and when one or more speakers are set to
“Small”, as described in section “Setting the Speaker
Configuration” ( page 56, 57).
If “LFE+Main” is set at “Subwoofer Setup”, “SW:LFE+Main”
( page 57) is displayed at the top right of the screen.
Set to “80 Hz” when using regular speakers. When using small
speakers, we recommend setting to a higher frequency.
1
2
If “LFE” is selected at “Setting the Subwoofer Setup” (
page 57), the frequencies can only be selected for speakers set
to “Small” at “Setting the Speaker Configuration” ( page
56, 57).
If “LFE+Main” is set at “Setting the Subwoofer Setup” (
page 57), the frequencies can be selected regardless of the
speaker size setting.
Press
FF GG
to select “Advanced” at the
“Crossover Frequency” screen.
Press
DD HH
to select the speaker, then press
FF GG
to set.
1
2
2 Setting the crossover frequency individually
for the different channels
Press ENTER.
3
1
2