Filter
Top Products
90
Set up speakers
7
Set up “Channel Select”
Use ui to select “Channel Select”, and then press
ENTER.
Channel Select
Subwoofer Measure
Audyssey Setup
Amp Assign
Channel Select
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
8
Use ui to select a channel, and then press ENTER.
Front
Select for setting the front speakers to be used. In this
case, go to step 9.
•“Front” can be set when “Assign Mode” is set to
“Front B”.
Subwoofer
Select for no subwoofers to be used. In this case, go
to step 10.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 11.
•“Surround Back” can be set when “Assign Mode” is
set to “Surround Back”.
9
Use o p to select a front speaker, and then press
ENTER.
A Select this to use front speaker A.
B
Select this to use front speaker B.
A+B
Select this to use front speakers A and B simultaneously.
10
Use o p to set whether or not a subwoofer channel is
measured, and then press ENTER.
Measure Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
11
Use o p to set whether or not a surround back
channel is measured, and then press ENTER.
Measure
(2spkrs)
Set for measuring two surround back speakers.
Measure
(1spkr)
Set for measuring a surround back speaker.
Skip
Set for no measuring of a surround back speaker.
12
Press o or BACK.
Proceed to page28
Preparation
step 5.
NOTE
After performing Audyssey
®
Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey
®
Setup again.
5
Use o p to select the
conguration of the connected
speakers, and then press
ENTER.
Surround Back
Setting for 7.1-channel playback using surround
back speakers.
ZONE2
Setting to assign the unit’s built-in power amplifier
for ZONE2 and output the audio in stereo.
Bi-AMP
Setting to use the front speakers via the bi-amp
connection.
Front B
Setting to use the second set of front speakers for
playback.
Front Height
Setting for 7.1-channel playback using front height
speakers.
Front Wide
Setting for 7.1-channel playback using front wide
speakers.
6
Press o or BACK to exit the “Amp Assign” setting.
Basic version
Advanced version
Informations
Advanced version
DVD