Filter
Top Products
124
Speakers
Setting items Setting details
Distances
Set distance from listening
position to speakers.
Measure beforehand the
distance from the listening
position to each speaker.
Unit : Set the unit of distance.
•Meters / Feet
Step : Set the minimum variable width of the distance.
•0.1m / 0.01m
•1ft / 0.1ft
Set Defaults : The “Distances” settings are returned to the default
settings.
•Yes : Reset to the defaults.
•No : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER, the “Reset to the default values?”
prompt is displayed. Select either “Yes” or
“No”, and press ENTER.
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer /
Surround L / Surround R / Surr. Back L
z
/ Surr. Back R
z
/ Front Wide L /
Front Wide R : Select speaker for distance setting.
z When the “Speaker Config.” – “Surr. Back” setting (vpage123) is
set to “1spkr”, “Surr. Back” is displayed.
•0.00m – 18.00m / 0.0ft – 60.0ft : Set the distance.
•The speakers that can be selected differ depending on the “Amp Assign”
(vpage122) and “Speaker Config.” (vpage122) settings.
•Default settings :
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer / Front
Wide L / Front Wide R : 3.60 m (12.0 ft)
Surround L / Surround R / Surr. Back L / Surr. Back R : 3.00 m (10.0 ft)
•Set the difference in the distance between the speakers to less than
6.00 m (20.0 ft).
NOTE
Speakers set to “None” in “Speaker Config.” (vpage 122) are not
displayed.
Setting items Setting details
Levels
Set the volume of the test
tone to be the same when it
is output from each speaker.
Test Tone Start : Output test tone.
•Front L / F. Height L / Center / F. Height R / Front R / Front Wide R /
Surround R / Surr. Back R
z
/ Surr. Back L
z
/ Surround L /
Front Wide L / Subwoofer : Select speaker to output test tone.
z When the “Speaker Config.” – “Surr. Back” setting (vpage123) is
set to “1spkr”, “Surr. Back” is displayed.
•–12.0dB – +12.0dB (0.0dB) : Adjust the volume.
When “Levels” is adjusted, the adjusted values are set for all the sound
modes.
NOTE
•Speakers set to “None” in the “Speaker Config.” (vpage 122)
settings are not displayed.
•When a headphones jack is inserted in the PHONES jack of this unit, the
“Levels” is not displayed.
Set Defaults : The “Levels” settings are returned to the default settings.
•Yes : Reset to the defaults.
•No : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER, the “Reset to the default values?”
prompt is displayed. Select either “Yes” or
“No”, and press ENTER.
Basic version
Advanced version
Informations
Advanced version
v See overleaf
DVD